User Manual

Unified IP MIB Reference 269
53-1003106-01
Chapter
18
Stacking MIB Definition
In this chapter
•Global objects for stacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 269
•Stacking configuration unit table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 270
•Stacking operation unit table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 271
Global objects for stacking
NOTE
This chapter presents the MIB objects for devices that support the stacking functionality. The
following MIB objects apply to the stacking devices, such as the FGS-STK, FLS-STK, Brocade FCX,
and Brocade ICX devices.
Name, OID, and syntax Access Description
snStackingGlobalConfigSt
ate
brcdIp.1.1.3.31.1.1
Syntax: Integer
Read-write Shows the state of the stacking feature:
• none(0) - Neutral
• enabled(1) - Stacking is enabled and can send and receive
packets.
• disabled(2) - Stacking is disabled and cannot send or receive
packets.
snStackingGlobalMacAddr
ess
brcdIp.1.1.3.31.1.2
Syntax: MAC address
Read-write Management MAC address of the stacking system. This is available so
you can change the management MAC address of the stack for
administrative purposes; however, it is strongly recommended that this
command should be used with extreme caution to prevent duplicate
MAC addresses. You must reboot the system before the new MAC
address takes effect.
This object is mutually exclusive from enabling the persistent MAC
timer.
Enter zero MAC addresses to remove the configured MAC address.
snStackingGlobalPersiste
ntMacTimerState
brcdIp.1.1.3.31.1.3
Syntax: Integer
Read-write The configured persistent MAC timer state for the stacking feature:
• enabled(0) - The persistent MAC timer is active and configured.
The persistent MAC timer is set as the default timer (60 minutes).
• disabled(1) - Deactivate the persistent MAC timer. It will stop the
use of persistent MAC addresses and use a new active stack
unit's base MAC address.