User Manual

Unified IP MIB Reference 335
53-1003106-01
Chapter
27
Trunk Port Configuration Group
In this chapter
•Trunk port configuration group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335
•Multi-slot trunk port table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 336
•Switch configuration summary group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 337
Trunk port configuration group
The trunk group feature allows you to manually configure multiple high-speed, load-sharing links
between two switches or routers or between a switch and router and a server.
NOTE
The following table is not supported on the Brocade MLXe, Brocade NetIron XMR, Brocade NetIron
MLX, Brocade NetIron CES, and Brocade NetIron CER series devices.
NOTE
In Ironware release 08.0.00a, “fdryLinkAggregationGroupTable” obsoletes “snTrunkTable”. For
more information on LAG MIBs, refer to Chapter 59, “LAG MIB Definition”.
The following objects contain configuration of trunk port memberships.
Name, OID, and syntax Access Description
snTrunkTable
brcdIp.1.1.3.6.1
None The trunk port table. A specific snTrunkTable consists of a number
of trunk port masks.
snTrunkIndex
brcdIp.1.1.3.6.1.1.1
Syntax: Integer32
Read-only Shows the number of the trunk port entries that can be
configured.
Valid values: 1 – 64
snTrunkPortMask
brcdIp.1.1.3.6.1.1.2
Syntax: PortMask
Read-write Shows the trunk port membership of the switch.
snTrunkType
brcdIp.1.1.3.6.1.1.3
Syntax: Integer
Read-write Indicates if the trunk port is connected to a switch or a server:
• switch(1)
• server(2)