User Manual

Unified IP MIB Reference 339
53-1003106-01
Chapter
28
RADIUS Group
In this chapter
•RADIUS general group. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 339
•RADIUS server table (IPv4) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 341
•RADIUS server table (FastIron X series IPv6 devices). . . . . . . . . . . . . . . . . 342
RADIUS general group
You can use a Remote Authentication Dial In User Service (RADIUS) server to secure the following
types of access to the switch or router:
• Telnet access
• SSH access
• Web management access
• Access to the Privileged EXEC level and CONFIG level of the CLI
The following objects provide information on RADIUS authentication and apply to all devices.
Name, OID, and syntax Access Description
snRadiusSNMPAccess
brcdIp.1.1.3.12.1.1
Syntax: Integer
Read-only Indicates if the RADIUS group MIB objects can be accessed by an
SNMP manager:
• disabled(0) – All RADIUS group MIB objects return a “general
error”.
• enabled(1)
Default: disabled(0)
snRadiusEnableTelnetAuth
brcdIp.1.1.3.12.1.2
Syntax: Integer
Read-write Indicates if Telnet authentication as specified by the
“snRadiusLoginMethod” object is enabled:
• disabled(0)
• enabled(1)
Default: disabled(0)
snRadiusRetransmit
brcdIp.1.1.3.12.1.3
Syntax: Integer
Read-write Indicates the number of authentication query retransmissions that
can be sent to the RADIUS server.
Valid values: 1 – 5
Default: 3
snRadiusTimeOut
brcdIp.1.1.3.12.1.4
Syntax: Integer
Read-write Specifies the number of seconds to wait for an authentication reply
from the RADIUS server. Each unit is one second.
Valid values: 1 – 60
Default: 3
snRadiusDeadTime
brcdIp.1.1.3.12.1.5
Syntax: Integer
Read-write Specifies the RADIUS server dead time. Each unit is one minute.
Valid values: 0 – 5
Default: 3