User Manual

Unified IP MIB Reference 347
53-1003106-01
Chapter
30
802.1X Authentication MIB
In this chapter
802.1X authentication scalar group types. . . . . . . . . . . . . . . . . . . . . . . . . . 347
802.1X port statistics table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 349
802.1X port configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 350
802.1x port state table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 350
802.1X MAC sessions table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 351
802.1x authentication global administration . . . . . . . . . . . . . . . . . . . . . . . 352
802.1X authentication scalar group types
The 802.1X authentication scalar group provides information that is displayed in the outputs of the
following CLI commands:
show dot1x
show dot1x configuration all
show dot1x configuration ethernet port
NOTE
The following sections present the SNMP MIB objects for 802.1X authentication. These MIB objects
are supported on the FastIron LS, FastIron GS, Brocade FCX, FastIron SX, and FastIron WS devices.
Name, OID, and syntax Access Description
brcdDot1xAuthGlobalConfigQ
uietperiod
brcdIp.1.1.3.38.1.1
Syntax: Unsigned32
Read-write If the Brocade device is unable to authenticate a client, this object
shows the amount of time, in seconds, the Brocade device waits
before it retries to authenticate that client.
The allowed range is from 1 through 4294967294.
Default: 60 seconds
brcdDot1xAuthGlobalConfigT
xPeriod
brcdIp.1.1.3.38.1.2
Syntax: Unsigned32
Read-write When a client does not return an Extensible Authentication
Protocol (EAP) response or identity frame, this object shows the
amount of time, in seconds, the Brocade device waits before
retransmitting the EAP-request or identity frame to the client.
The allowed range is from 1 through 4294967294.
Default: 30 seconds
brcdDot1xAuthGlobalConfigS
uppTimeOut
brcdIp.1.1.3.38.1.3
Syntax: Unsigned32
Read-write When a supplicant (client) does not respond to an EAP-request
frame, this object shows the amount of time, in seconds, before
the Brocade device retransmits the frame.
The allowed range is from 1 through 4294967294.
Default: 30 seconds