User Manual

458 Unified IP MIB Reference
53-1003106-01
IP interface port access table
46
IP interface port access table
The following table determines if the port is for incoming or outgoing traffic and the filter used on
the interface.
NOTE
The following table is not supported on the Brocade MLXe, Brocade NetIron MLX, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snRtIpPortAddrType
brcdIp.1.2.2.6.1.4
Syntax: Integer
Read-write Shows the port type of the entry:
• primary(1)
• secondary(2)
Default: primary(1)
snRtIpPortRowStatus
brcdIp.1.2.2.6.1.5
Syntax: Integer
Read-write Controls the management of the table rows. The following values can be
written:
• delete(3) – Delete the row.
• create(4) – Create a new row.
• modify(5) – Modify an existing row.
If the row exists, then a set with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
• noSuch(0) – No such row.
• invalid(1) – Row is inoperative.
• valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snRtIpPortAccessTable
brcdIp.1.2.2.7
None IP port access table.
snRtIpPortAccessPortIn
dex
brcdIp.1.2.2.7.1.1
Syntax: PortIndex
Read-only The index for an entry in the IP port access table.
For FastIron or NetIron products, the value of this object is from 1
through 42.
snRtIpPortAccessDirecti
on
brcdIp.1.2.2.7.1.2
Syntax: Integer
Read-only Specifies if the port is for incoming or outgoing traffic:
• in(1)
• out(2)