User Manual

Unified IP MIB Reference 463
53-1003106-01
Chapter
47
IPv6 MIB Definition
In this chapter
•ECMP MIB objects . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 463
NOTE
The MIB objects presented in this chapter are supported on the FastIron devices that support IPv6.
ECMP MIB objects
The SNMP Equal-Cost Multi-Path (ECMP) MIB object is used to configure ECMP for IPv6 using
SNMP. ECMP enables the router to balance traffic to a specific destination across multiple
equal-cost paths.
To use these objects, perform the following steps.
1. Enable ECMP for RIP using the snRtIpRipEcmpEnable MIB object.
IP load sharing is enabled by default. However, ECMP must be enabled for RIP IP load sharing.
2. Enable IPv6 load sharing using the fdryIpv6LoadShare MIB object.
IPv6 load sharing is enabled by default. If it needs to be enabled, set fdryIpv6LoadShare to 1.
3. Configure the maximum number of load sharing paths for IPv6 using the
fdryIpv6LoadShareNumOfPaths MIB object.
Name, OID, and syntax Access Description
fdryIpv6LoadShare
brcdIp.1.2.17.1.1.1
Syntax: RtrStatus
Read-write This object directs the IPv6 traffic to distribute the traffic load to IPv6
routes if more than one IPv6 route is available:
• 0 — Disables IPv6 load sharing.
• 1 — Enables IPv6 load sharing.
fdryIpv6LoadShareNumOf
Paths
brcdIp.1.2.17.1.1.2
Syntax: Unsigned32
Read-write Enter the number of IPv6 routes to be used to share a load. Enter a
value from 2 through 6.