User Manual

470 Unified IP MIB Reference
53-1003106-01
IPX RIP filter table
48
IPX RIP filter table
The following table allows you to define filters that a router uses to block RIP routes being
advertised to other parts of the network.
snIpxFwdFilterSrcNet
brcdIp.1.2.1.5.1.1.4
Syntax: NetNumber
Read-write Indicates the source network number.
snIpxFwdFilterSrcNode
brcdIp.1.2.1.5.1.1.5
Syntax: Physical address
Read-write Indicates the source node number.
snIpxFwdFilterDestNet
brcdIp.1.2.1.5.1.1.6
Syntax: NetNumber
Read-write Indicates the destination network number.
snIpxFwdFilterDestNode
brcdIp.1.2.1.5.1.1.7
Syntax: Physical address
Read-write Indicates the destination node number.
snIpxFwdFilterRowStatus
brcdIp.1.2.1.5.1.1.8
Syntax: Integer
Read-write Controls the management of the table rows. The following values can
be written:
• delete(3) – Delete the row.
• create(4) – Create a new row.
• modify(5) – Modify an existing row.
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
• noSuch(0) – No such row.
• invalid(1) – Row is inoperative.
• valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snIpxRipFilterTable
brcdIp.1.2.1.6.1
None The IPX RIP filter table.
snIpxRipFilterId
brcdIp.1.2.1.6.1.1.1
Syntax: Integer
Read-only The ID for an entry.
snIpxRipFilterAction
brcdIp.1.2.1.6.1.1.2
Syntax: Integer
Read-write Shows what action to take if the IPX packet matches this filter:
• deny(0)
• permit(1)
snIpxRipFilterNet
brcdIp.1.2.1.6.1.1.3
Syntax: NetNumber
Read-write Indicates the IPX RIP filter network number.