User Manual
Unified IP MIB Reference 487
53-1003106-01
BGP4 neighbor general configuration table
49
snBgp4NeighGenCfgDefOriginate
brcdIp.1.2.11.6.1.1.3
Syntax: Integer
Read-write Indicates if the default originate for this neighbor is enabled:
• disabled(0)
• enabled(1)
If enabled, the device sends the default route 0.0.0.0 to the
neighbor.
snBgp4NeighGenCfgEbgpMultihop
brcdIp.1.2.11.6.1.1.4
Syntax: Integer
Read-write Indicates if the EBGP multihop for this neighbor is enabled.
• disabled(0)
• enabled(1)
If enabled, the neighbor is more than one hop away and that
the session type with the neighbor is thus EBGP multihop.
Default: disabled(0)
snBgp4NeighGenCfgMaxPrefix
brcdIp.1.2.11.6.1.1.5
Syntax: Integer32
Read-write Specifies the maximum number of IP network prefixes
(routes) that can be learned from the specified neighbor or
peer group. You can specify a value from 0 through
4294967295.
Default: 0 (unlimited)
The minimum value of the maximum prefix is defined by the
“snBgp4GenNeighPrefixMinValue” object. The maximum
value of the maximum prefix is defined by the
“snBgp4GenOperRoutes” object.
snBgp4NeighGenCfgNextHopSelf
brcdIp.1.2.11.6.1.1.6
Syntax: Integer
Read-write Indicates if the option that allows the router to list itself as
the next hop in the updates sent to the specified neighbor
is enabled:
• disabled(0)
• enabled(1)
Default: disabled(0)
snBgp4NeighGenCfgRemoteAs
brcdIp.1.2.11.6.1.1.7
Syntax: Integer
Read-write Specifies the AS that the remote neighbor is in.
Valid values: 1 – 65535
Default: No default
snBgp4NeighGenCfgSendComm
brcdIp.1.2.11.6.1.1.8
Syntax: Integer
Read-write Indicates if the option to send community attributes in
updates to specified neighbors is enabled:
• disabled(0)
• enabled(1)
Default: disabled(0)
snBgp4NeighGenCfgWeight
brcdIp.1.2.11.6.1.1.9
Syntax: Integer
Read-write Assigns a weight to a neighbor connection.
BGP4 prefers larger weights over smaller weights.
Valid values: 0 – 65535
Default: 0
snBgp4NeighGenCfgWeightFilterLi
st
brcdIp.1.2.11.6.1.1.10
Syntax: OCTET STRING
Read-write Specifies a weight that the device applies to routes received
from the neighbor that match the AS-Path filter or ACL.
Valid values: 1 – 0xFFFF. Each integer is represented by two
octets.
Name, OID, and syntax Access Description