User Manual

Unified IP MIB Reference 511
53-1003106-01
OSPF interface configuration tables
50
OSPF interface configuration tables
The OSPF interface table augments the ifTable with OSPF-specific information. The following table
is deprecated by “OSPF interface 2 configuration table” (snOspfIf2Table).
OSPF interface configuration table
Name, OID, and syntax Access Description
snOspfAreaRangeTable
brcdIp.1.2.4.3.1
None The area range table.
snOspfAreaRangeAreaID
brcdIp.1.2.4.3.1.1.1
Syntax: AreaID
Read-only Specifies the ID of the area where the address range can be
found. The “snOspfAreaRangeAreaIdFormat” object determines
the format of this object.
snOspfAreaRangeNet
brcdIp.1.2.4.3.1.1.2
Syntax: IpAddress
Read-only Specifies the IP address of the net or subnet indicated by the
range.
snOspfAreaRangeMask
brcdIp.1.2.4.3.1.1.3
Syntax: IpAddress
Read-write Specifies the subnet mask that pertains to the net or subnet.
snOspfAreaRangeRowStatus
brcdIp.1.2.4.3.1.1.4
Syntax: Integer
Read-write Controls the management of the table rows. The following values
can be written:
• delete(3) – Deletes the row.
• create(4) – Creates a new row.
• modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
• noSuch(0) – No such row.
• invalid(1) – Row is inoperative.
• valid(2) – Row exists and is valid.
snOspfAreaRangeAreaIdFormat
brcdIp.1.2.4.3.1.1.5
Syntax: Integer
Read-only Specifies the format of how area ID will be entered in the
“snOspfAreaRangeAreaID” object:
• integer(0) – Integer
• ipAddress(1) – IP Address
Name, OID, and syntax Access Description
snOspfIfTable
brcdIp.1.2.4.4.1
None The OSPF interface configuration table.
snOspfIfPort
brcdIp.1.2.4.4.1.1.1
Syntax: Integer32
Read-only The physical router port of this OSPF interface.
snOspfIfAreaId
brcdIp.1.2.4.4.1.1.2
Syntax: AreaID
Read-write Specifies the address of the area in a 32-bit integer. This
address uniquely identifies the area to which the interface
connects. Area ID 0.0.0.0 is used for the OSPF backbone.
Default:’00000000’h, which is equal to 0.0.0.0 .