User Manual

Unified IP MIB Reference 521
53-1003106-01
OSPF neighbor table
50
OSPF neighbor table
The OSPF neighbor table describes non-virtual neighbors in the locality of the router.
References:
• RFC 1583 “OSPF Version 2”, section 10 The Neighbor Data Structure
• RFC 1583 “OSPF Version 2”, section 12.1.2 Options
snOspfRedisRipMetricValue
brcdIp.1.2.4.6.1.1.9
Syntax: Integer
Read-write Specifies the cost of using RIP on this interface.
Valid values: 1 – 15 hops
snOspfRedisRowStatus
brcdIp.1.2.4.6.1.1.10
Syntax: Integer
Read-write Controls the management of the table rows. The following values
can be written:
• delete(3) – Deletes the row.
• create(4) – Creates a new row.
• modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
• noSuch(0) – No such row.
• invalid(1) – Row is inoperative.
• valid(2) – Row exists and is valid.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfNbrTable
brcdIp.1.2.4.7.1
None A table of non-virtual neighbor information.
snOspfNbrEntryIndex
brcdIp.1.2.4.7.1.1.1
Syntax: Integer32
Read-only The table entry index of this neighbor.
snOspfNbrPort
brcdIp.1.2.4.7.1.1.2
Syntax: Integer32
Read-only Shows the physical port ID of this neighbor.
snOspfNbrIpAddr
brcdIp.1.2.4.7.1.1.3
Syntax: IpAddress
Read-only Shows the IP address of this neighbor.
snOspfNbrIndex
brcdIp.1.2.4.7.1.1.4
Syntax: Integer32
Read-only Contains an index of each neighbor’s port and IP address.
snOspfNbrRtrId
brcdIp.1.2.4.7.1.1.5
Syntax: RouterID
Read-only Specifies the IP address of the neighboring router in the autonomous
system. The value of this object is a 32-bit integer.
Default: ’00000000’h, which is equal to 0.0.0.0