User Manual

Unified IP MIB Reference 29
53-1003106-01
RFC 2932: IPv4 Multicast Routing MIB
2
ipMRouteInterfaceTable
(IP multicast route interface table)
This is the IP multicast route table for interfaces.
The show ip pim interface command is used to display information about this table.
The following interface-level commands are used to create an entry to the IP multicast route
interface table:
• ip pim
• ip pim-sparse
• ip pim ttl-threshold value
The SET request is not supported for this table.
ipMRouteNextHopProtocol 1.3.6.1.2.1.83.1.1.3.1.10 Yes, but read-only.
ipMRouteNextHopPkts 1.3.6.1.2.1.83.1.1.3.1.11 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.
Object Object identifier Supported?
ipMRouteInterfaceIfIndex 1.3.6.1.2.1.83.1.1.4.1.1 Yes
ipMRouteInterfaceTtl 1.3.6.1.2.1.83.1.1.4.1.2 Yes, but read-only.
ipMRouteInterfaceProtocol 1.3.6.1.2.1.83.1.1.4.1.3 Yes, but read-only.
ipMRouteInterfaceRateLimit 1.3.6.1.2.1.83.1.1.4.1.4 No
ipMRouteInterfaceInMcastOctets 1.3.6.1.2.1.83.1.1.4.1.5 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.
ipMRouteInterfaceOutMcastOctets 1.3.6.1.2.1.83.1.1.4.1.6 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.
Object Object identifier Supported?