User Manual

Unified IP MIB Reference 539
53-1003106-01
Chapter
52
Router IP MIB Definition
In this chapter
•IP RIP general group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 539
•IP RIP port configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 541
•IP RIP redistribution table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 541
•IP RIP route filter table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 543
•IP RIP neighbor filter table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 544
•IP RIP port access table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 545
•Global RIP statistics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 545
IP RIP general group
The Routing Information Protocol (RIP) is an IP route exchange protocol that uses a distance vector
(a number representing distance) to measure the cost of a given route. The cost is a distance
vector because the cost often is equivalent to the number of hops between the Layer 3 Switch and
the destination network.
A Layer 3 Switch can receive multiple paths to a destination. A RIP route can have a maximum cost
of 15.
The following objects are general objects for RIP.
Name, OID, and syntax Access Description
snRtIpRipEnable
brcdIp.1.2.3.1.1
Syntax: Integer
Read-write Indicates if IP RIP routing is enabled:
• disabled(0)
• enabled(1)
Default: disabled(0)
snRtIpRipUpdateTime
brcdIp.1.2.3.1.2
Syntax: Integer
Read-write Specifies the RIP update interval in seconds.
Valid values: 1 – 21845 seconds
snRtIpRipRedisEnable
brcdIp.1.2.3.1.3
Syntax: Integer
NOTE: This object is not
supported on the
Brocade NetIron and
Brocade FastIron
devices.
Read-write Indicates if redistribution of static routes from the IP route table
into RIP is enabled:
• disabled(0)
• enabled(1)
Default: disabled(0)
snRtIpRipRedisDefMetric
brcdIp.1.2.3.1.4
Syntax: Integer
Read-write Shows the default metric to be used when static routes are
redistributed to RIP.
Valid values: 1 – 15