User Manual

32 Unified IP MIB Reference

53-1003106-01

RFC 2934: Protocol Independent Multicast MIB for IPv4

The following PIM MIB objects are supported on the Brocade NetIron and Brocade FastIron devices.

On the Brocade NetIron XMR, Brocade NetIron MLX, Brocade NetIron CES, and Brocade NetIron

CER series devices, only default VRF is supported.

Support for RFC 2934 in these devices is presented in the following sections.

pimInterfaceTable (PIM interface table)

Use the show ip pim interface command to display information about the PIM interface table.

The SET request is not supported for this table.

Object Object identifier Supported?

igmpCacheAddress 1.3.6.1.2.1.85.1.2.1.1 Yes

igmpCacheIfIndex 1.3.6.1.2.1.85.1.2.1.2 Yes

igmpCacheSelf 1.3.6.1.2.1.85.1.2.1.3 Yes, but read-only.

igmpCacheLastReporter 1.3.6.1.2.1.85.1.2.1.4 Yes, but read-only.

NOTE: On Brocade NetIron MLX

Brocade MLXe, Brocade

NetIron XMR

, Brocade

NetIron CES, and Brocade

NetIron CER series

devices,

the constant value for this

object is 0.

igmpCacheUpTime 1.3.6.1.2.1.85.1.2.1.5 Yes, but read-only.

igmpCacheExpiryTime 1.3.6.1.2.1.85.1.2.1.6 Yes, but read-only.

igmpCacheStatus 1.3.6.1.2.1.85.1.2.1.7 Yes, but read-only.

NOTE: On Brocade NetIron MLX

Brocade MLXe, Brocade

NetIron XMR

, Brocade

NetIron CES, and Brocade

NetIron CER series

devices,

the constant value for this

object is active(1).

igmpCacheVersion1HostTimer 1.3.6.1.2.1.85.1.2.1.8 Yes, but read-only.

Object Object identifier Supported?

pimJoinPruneInterval 1.3.6.1.3.61.1.1.1 Yes, but read-only.

NOTE: The SET operation is not

supported.

Object Object identifier Supported?

pimInterfaceIfIndex 1.3.6.1.3.61.1.1.2.1.1 Yes

pimInterfaceAddress 1.3.6.1.3.61.1.1.2.1.2 Yes, but read-only.