User Manual

Unified IP MIB Reference 559
53-1003106-01
FSRP interface table
54
snFsrpIfState
brcdIp.1.2.7.2.1.1.8
Syntax: Integer
Read-only Specifies the state of the FSRP router interface:
init(0) – Initialization state
negotiating(1) – Negotiating state
standby(2) – Standby state
active(3) – Active state
snFsrpIfKeepAliveTime
brcdIp.1.2.7.2.1.1.9
Syntax: Integer
Read-write Defines the heartbeat of the interface.
Valid values: 1 – 120 seconds
Default: 3 seconds
snFsrpIfRouterDeadTim
e
brcdIp.1.2.7.2.1.1.10
Syntax: Integer
Read-write Defines the hold time of the FSRP router.
Valid values: 3 – 255 seconds
Default: 9 seconds
snFsrpIfChassisTrackPor
tMask
brcdIp.1.2.7.2.1.1.11
Syntax: OCTET STRING
Read-write This object is replaced by the “snFsrpIfTrackPortList” object.
This object shows the chassis router FSRP track port membership.
It specifies the identity of the physical port whose state is to be
monitored. Each bit is a port of the system.
Valid values: Up to 32 octets
Default: 0
If this object is configured, then the preference level of this interface will
be adjusted dynamically, depending on the state of the track port. The
preference level is configured in the “snFsrpIfPreferLevel” object. The
interface’s preference level is reduced by the value of the preference
level parameter when the track port states first changes from up to
down. When the track port comes up, the interface’s preference level is
increased by the amount specified by the preference level.
snFsrpIfTrackPortList
brcdIp.1.2.7.2.1.1.12
Syntax: OCTET STRING
Read-write Shows the router FSRP physical track port membership.
It specifies the identity of the physical port whose state is to be
monitored. Each port index is a 16-bit integer in big-endian order. The
first 8-bit is the slot number, the other eight bits is the port number.
Default: 0 length octet string
If this object is configured, then the preference level of this interface will
be adjusted dynamically, depending on the state of the track port. The
preference level is configured in the “snFsrpIfPreferLevel” object. The
interface’s preference level is reduced by the value of the preference
level parameter when the track port states first changes from up to
down. When the track port comes up, the interface’s preference level is
increased by the amount specified by the preference level.
Name, OID, and syntax Access Description