User Manual

34 Unified IP MIB Reference
53-1003106-01
RFC 2934: Protocol Independent Multicast MIB for IPv4
2
pimIpMRouteNextHopTable
(PIM IP multicast route next hop table)
The show ip pim mcache sg command displays information about the PIM IP multicast route next
hop table.
pimRpTable (PIM RP table)
NOTE
On the Brocade NetIron MLX, Brocade MLXe, Brocade NetIron XMR, Brocade NetIron CES, and
Brocade NetIron CER series devices, this table has been replaced by “pimRpSetTable (PIM RP set
table)”
pimIpMRouteUpstreamAssertT
imer
1.3.6.1.3.61.1.1.4.1.1 Yes, but read-only.
pimIpMRouteAssertMetric 1.3.6.1.3.61.1.1.4.1.2 Yes, but read-only.
pimIpMRouteAssertMetricPref 1.3.6.1.3.61.1.1.4.1.3 Yes, but read-only.
pimIpMRouteAssertRPTBit 1.3.6.1.3.61.1.1.4.1.4 No.
NOTE: This object is not supported on the Brocade
MLXe, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and
Brocade NetIron CER series devices.
pimIpMRouteFlags 1.3.6.1.3.61.1.1.4.1.5 No.
NOTE: This object is not supported on the Brocade
MLXe, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and
Brocade NetIron CER series devices.
Object Object identifier Supported?
ipMRouteNextHopGroup 1.3.6.1.2.1.83.1.1.3.1.1 Yes
ipMRouteNextHopSource 1.3.6.1.2.1.83.1.1.3.1.2 Yes
ipMRouteNextHopSourceM
ask
1.3.6.1.2.1.83.1.1.3.1.3 Yes
ipMRouteNextHopIfIndex 1.3.6.1.2.1.83.1.1.3.1.4 Yes
ipMRouteNextHopAddress 1.3.6.1.2.1.83.1.1.3.1.5 Yes
pimIpMRouteNextHopPrune
Reason
1.3.6.1.3.61.1.1.7.1.2 Yes, but read-only.
Object Object identifier Supported?
pimRPGroupAddress 1.3.6.1.3.61.1.1.5.1.1 Yes, but read-only and only active groups.
pimRPAddress 1.3.6.1.3.61.1.1.5.1.2 Yes, but read-only.
pimRPState 1.3.6.1.3.61.1.1.5.1.3 Yes, but read-only and value is always up(1).
pimRPStateTimer 1.3.6.1.3.61.1.1.5.1.4 No.
Object Object identifier Supported?