Installation Procedure (Supporting VDX 6740T) User guide

16 of 20 Universal Four-Post Rack Kit Installation Procedure
53-1002944-01 Rev.B
Installing the switch in the rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack, as shown in Figure 10, providing temporary support under the switch until the
rail kit is secured to the rack.
2. Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer
nuts. Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 10 Positioning the switch in the rack
1 Screws, 10-32 x 5/8-in., panhead Phillips 2 Retainer nuts, 10-32