Installation Procedure (Supporting VDX 6740T) User guide

Universal Four-Post Rack Kit Installation Procedure 9 of 20
53-1002944-01 Rev.B
Installing the switch in the rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack, as shown in Figure 4, providing temporary support under the switch until the rail
kit is secured to the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts. Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 4 Positioning the switch in the rack
1 Screws, 10-32 x 5/8-in., panhead Phillips 2 Retainer nuts, 10-32