(Supporting ADX v03.1.00) Owner's manual
Table Of Contents
- Contents
- Preface
- Introduction to the Brocade Virtual ADX Web Interface
- Navigating the Web Interface
- Navigating the Dashboard
- Configuration Overview
- System Settings
- Network Settings
- Traffic Settings
- GSLB Settings
- Security Settings
- Monitoring Overview
- Viewing System Information
- Viewing Network Status
- Viewing Traffic Statistics
- Viewing Security Statistics
- Maintenance Overview
- Managing Software Images
- Restarting the System
- License Management
- Packet Capture
- Accessing the CLI
- Retrieving System Information for Technical Support
- Troubleshooting
- Config Template XML Schema
- Managing Config Templates through the CLI
168 Brocade Virtual ADX Graphical User Interface Guide
53-1003242-01
TACACS controls
9
TACACS Settings tab
The TACACS Settings tab lets you configure the basic settings for a TACACS Server. See Figure 132.
FIGURE 132 TACACS Settings tab
Table 32 describes the TACACS Settings tab controls and their functions.
Providing TACACS settings
Before you create a TACACS server, you must set the following general configuration values. These
apply to all TACACS servers.
To set the general TACACS settings:
1. Select the Configure tab.
2. Click Security in the tab menu bar.
3. From the sidebar, select TACACS.
TABLE 32 TACACS Settings tab controls
Control Description
Key Enter a TACACS password key up to 32 characters.
Encryption Select this check box to enable encryption of the key.
Timeout Time delay before the connection times out. (range 1–15 seconds, default is
3seconds)
Retransmit Number of attempts to retransmit connection information. (range 0–5, default is 3)
Dead Time Length of time that the application skips a nonresponsive TACACS server for
transaction requests. (range 1–5 seconds, default is 3 seconds)
VLAN ID Virtual LAN Identifier for this server. (Optional)
Source Interface Source Interface for this server. (Optional)