(Supporting ADX v03.1.00) Owner's manual
Table Of Contents
- Contents
- Preface
- Introduction to the Brocade Virtual ADX Web Interface
- Navigating the Web Interface
- Navigating the Dashboard
- Configuration Overview
- System Settings
- Network Settings
- Traffic Settings
- GSLB Settings
- Security Settings
- Monitoring Overview
- Viewing System Information
- Viewing Network Status
- Viewing Traffic Statistics
- Viewing Security Statistics
- Maintenance Overview
- Managing Software Images
- Restarting the System
- License Management
- Packet Capture
- Accessing the CLI
- Retrieving System Information for Technical Support
- Troubleshooting
- Config Template XML Schema
- Managing Config Templates through the CLI
46 Brocade Virtual ADX Graphical User Interface Guide
53-1003242-01
Device management
5
• Switch Standby
• TCP SYN Limit
• Other Traps
• Authentication
• Locked Address Violation
• STP New Root
• STP Topology Change
• OSPF
Use the Traps tab to perform the following functions:
• Set or disable an individual trap by marking or unmarking the check box for that trap.
• Click Expand All to see all the traps.
• Click Collapse All to collapse the tree so that only the top-level headers are displayed.
• Click Select All to activate all the traps.
• Click Unselect All to disable all traps.
Trap Receivers tab
The Trap Receivers tab displays an editable list of Trap Receivers on the server.
To view the Trap Receivers page, perform the following actions in the Configure tab:
1. Click System on the menu bar.
2. From the sidebar, select Device Management.
3. Click SNMP in the sidebar sub-menu to display the SNMP Settings tab.