(Supporting ADX v03.1.00) Owner's manual

Brocade Virtual ADX Graphical User Interface Guide 61
53-1003242-01
Configuring static routes
6
3. Click New at the bottom of the Summary page.
The Static Route - new tab is displayed. See Figure 49.
FIGURE 49 Static Route - new tab
4. Provide the following information:
• IP Version: Click IPv4 or IPv6 to select the version of the IP address. By default, IPv4 is
selected as the version of the IP address.
• Destination Network: Enter the IP address of the destination route.
• Subnet Mask: Enter the subnet mask in a class-based format.
• Gateway: For IPv4, click either IP Address, Interface, or Null0 and provide the required
information. For IPv6, enter the information for both IP Address and Interface and choose
whether or not to select Null0:
• IP Address — The IP address of the gateway.
• Interface — The interface of the gateway.
• Null0 — Select Null0 or leave it unselected.
• Metric: Enter the value for comparing two routes for the same destination in the IP route
table. The range is from 1 through 16. The default metric is 1.
• Distance: Enter the distance value for comparing a route with routes from other route
sources to the same destination before adding the route in the IP route table. The range is
from 1 through 255. The default value is 1.
5. Click Apply to save the entries.
Click Reset to revert the configuration to the previous configured values.
To modify the configured static route information, in the Summary table, select an entry and
click Edit or double-click the entry. You can also delete a configuration by clicking Delete.
For more information on the static routes, refer to the Brocade Virtual ADX Switch and Router
Guide.