Reference (Supporting ADX v03.1.00) Owner's manual

Brocade Virtual ADX MIB Reference 99
53-1003312-01
Chapter
9
VLANs
In this chapter
•VLAN by port information table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99
•VLAN by port membership table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103
•Port VLAN configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104
•VLAN by protocol configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 107
•VLAN by IP subnet configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 109
•vVLAN by port membership table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111
•Port VLAN configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111
VLAN by port information table
The following table applies to a Layer 2 devices if the object “snSwGroupOperMode” on page 23 is
configured with a value of vlanByPort(2), allowing switch ports to be configured with a VLAN ID.
Each VLAN switch port could have a number of VLAN IDs.
Name, OID, and Syntax Access Description
snVLanByPortTable
brcdIp.1.1.3.2.1
None The VLAN by Port Information Table for Layer 2 switches.
snVLanByPortEntry
brcdIp.1.1.3.2.1.1
None An entry in the VLAN By Port Information table.
snVLanByPortVLanIndex
brcdIp.1.1.3.2.1.1.1
Syntax: Integer
Read only Shows the index to this table.
The VLAN ID number must not be greater than the value of the
object “snVLanGroupVlanMaxEntry” on page 25. Each VLAN
Identifier can be a member of multiple ports.
snVLanByPortVLanId
brcdIp.1.1.3.2.1.1.2
Read-write The VLAN ID index to the this table. Each VLAN Identifier can be a
member of multiple ports.
Valid values: 1 – 4095.
snVLanByPortPortMask
brcdIp.1.1.3.2.1.1.3
Syntax: PortMask
Read-write Applies only to ServerIron Stackable devices.
Shows the standalone switch VLAN port membership. This object
was obsoleted for Chassis devices.