Reference (Supporting ADX v03.1.00) Owner's manual

Brocade Virtual ADX MIB Reference 149
53-1003312-01
OSPF neighbor table
OSPF neighbor table
The OSPF Neighbor Table describes non-virtual neighbors in the locality of the router.
Reference:
• RFC 1583 “OSPF Version 2”, section 10 The Neighbor Data Structure
• RFC 1583 “OSPF Version 2”, section 12.1.2 Options
snOspfRedisRipMetricValue
brcdIp.1.2.4.6.1.1.9
Syntax: Integer
Read-write Specifies the cost of using RIP on this interface.
Valid values: 1 – 15 hops.
snOspfRedisRowStatus
brcdIp.1.2.4.6.1.1.10
Syntax: Integer
Read-write Controls the management of the table rows. The values that can be
written are:
• delete(3) – Delete the row
• create(4) – Create a new row
• modify(5) – Modify an existing row
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
• noSuch(0) – No such row
• invalid(1) – Row is inoperative
• valid(2) – Row exists and is valid
Name, OID, and Syntax Access Description
Name, OID, and Syntax Access Description
snOspfNbrTable
brcdIp.1.2.4.7.1
None A table of non-virtual neighbor information.
snOspfNbrEntry
brcdIp.1.2.4.7.1.1
None An entry in the OSPF Neighbor Information Table. One entry represents one
neighbor.
snOspfNbrEntryIndex
brcdIp.1.2.4.7.1.1.1
Syntax: Integer32
Read only The table entry index of this neighbor.
snOspfNbrPort
brcdIp.1.2.4.7.1.1.2
Syntax: Integer32
Read only Shows the physical port ID of this neighbor.
snOspfNbrIpAddr
brcdIp.1.2.4.7.1.1.3
Syntax: IpAddress
Read only Shows the IP address of this neighbor.
snOspfNbrIndex
brcdIp.1.2.4.7.1.1.4
Syntax: Integer32
Read only Contains an index of each neighbor’s port and IP address.
snOspfNbrRtrId
brcdIp.1.2.4.7.1.1.5
Syntax: RouterID
Read only Specifies the IP address of the neighboring router in the Autonomous
System. The value of this object is a A 32-bit integer.
Default: ’00000000’h, which is equal to 0.0.0.0