Reference (Supporting ADX v03.1.00) Owner's manual

156 Brocade Virtual ADX MIB Reference
53-1003312-01
OSPF interface status table
OSPF interface status table
The OSPF Interface Status Table describes the interfaces from the viewpoint of OSPF. It augments
the ifStatusTable with OSPF specific information.
snOspfAreaStatusStubMetric
brcdIp.1.2.4.11.1.1.4
Syntax: BigMetric
Read only The metric value applied at the default type of service
(ospfMetric). By default, this equals the least metric at the type
of service among the interfaces to other areas. This object exist
only if the value of snOspfAreaSummary is
snOspfAreaSummary(2); Otherwise, an SNMP_GET or GET_NEXT
attempt of this Object will return NO_SUCH_NAME.
snOspfAreaStatusSpfRuns
brcdIp.1.2.4.11.1.1.5
Syntax: Counter32
Read only Shows the number of times that the intra-area route table has
been recalculated using this area’s link-state database.
snOspfAreaStatusAreaBdrRtrCou
nt
brcdIp.1.2.4.11.1.1.6
Syntax: Gauge32
Read only Show the number of area border routers that are reachable
within this area. This is initially zero, the default, and is
calculated in each shortest path first (SPF) pass.
snOspfAreaStatusASBdrRtrCount
brcdIp.1.2.4.11.1.1.7
Syntax: Gauge32
Read only Shows the total number of Autonomous System border routers
that are reachable within this area. This is initially zero, the
default, and is calculated in each SPF pass.
snOspfAreaStatusLSACount
brcdIp.1.2.4.11.1.1.8
Syntax: Gauge32
Read only Shows the total number of link-state advertisements in this
area’s link-state database, excluding AS external LSAs.
Default: 0
snOspfAreaStatusLSACksumSum
brcdIp.1.2.4.11.1.1.9
Syntax: Integer32
Read only Shows the total link-state advertisements of area’s link-state
database. This number is a 32-bit unsigned sum of the LS
checksums, excluding external (LS type 5) link-state
advertisements. The value can be used to determine if there has
been a change in a router’s link-state database, and to compare
the link-state database of two routers.
Default: 0
snOspfAreaStatusAreaIdFormat
brcdIp.1.2.4.11.1.1.10
Syntax: Integer
Read only Specifies the format of how Area ID will be entered in the
“snOspfAreaStatusAreaId” object:
• integer(0) – Integer.
• ipAddress(1) – IP address.
Name, OID, and Syntax Access Description
Name, OID, and Syntax Access Description
snOspfIfStatusTable
brcdIp.1.2.4.12.1
None The OSPF Interface Status Table.
snOspfIfStatusEntry
brcdIp.1.2.4.12.1.1
None An entry in the OSPF Interface Status Table. Each entry represents
one interface from the viewpoint of OSPF.
snOspfIfStatusEntryIndex
brcdIp.1.2.4.12.1.1.1
Syntax: Integer32
Read only The ID of an entry in the OSPF Interface Status Table.