Reference (Supporting ADX v03.1.00) Owner's manual

250 Brocade Virtual ADX MIB Reference
53-1003312-01
Objects for traps
Enable OSPF trap objects
The following are support objects for the OSPF traps.
fdryTrapReceiverSecurityLevel
brcdIp.1.1.10.1.1.1.1.7
Syntax: SecurityLevel
Read-create Used for USM (SNMPv3) security model to specify the level of
security. The security name is provided by
fdryTrapReceiverCommunityOrSecurityName.
Default: noAuth
fdryTrapReceiverRowStatus
brcdIp.1.1.10.1.1.1.1.8
Syntax: RowStatus
Read-create This variable is used to create, modify, or delete a row in this
table. When a row in this table is in active(1) state, no objects in
that row can be modified except this object.
Name, OID, and Syntax Access Description
snOspfSetTrap
brcdIp.1.2.1.14.16.1.1
Syntax: OctetString
Read-write Indicates if specific OSPF traps are enabled.
This object contains four octets, serving as a bit map for the trap
events defined by the OSPF traps. A value of 1 in the bit field
indicates that the trap is enabled. The right-most bit (least
significant) represents Trap 0.
snOspfConfigErrorType
brcdIp.1.2.4.15.2
Syntax: Integer
Read only Indicates the potential types of configuration conflicts used by the
ospfConfigError and ospfConfigVirtError traps.
• badVersion(1)
• areaMismatch(2)
• unknownNbmaNbr(3) – Router is eligible
• unknownVirtualNbr(4)
• authTypeMismatch(5)
• authFailure(6)
• netMaskMismatch(7)
• helloIntervalMismatch(8)
• deadIntervalMismatch(9)
• optionMismatch(10)}
snOspfPacketType
brcdIp.1.2.4.15.3
Syntax: Integer
Read only Indicates the OSPF packet type in the trap.
• hello(1)
• dbDescript(2)
• lsReq(3)
• lsUpdate(4)
• lsAck(5)}
snOspfPacketSrc
brcdIp.1.2.4.15.4
Syntax: IpAddress
Read only Shows the IP address of an inbound packet that cannot be identified
by a neighbor instance.
snOspfTrapsGenerationMode
brcdIp.1.2.4.15.5
Syntax: RtrStatus
Read-write Indicates if this router has been enabled to generate OSPF traps.
• disabled(0) – OSPF traps cannot be generated by this router,
even if the object “snOspfSetTrap” is set to generate traps.
• enabled(1) – OSPF traps can be generated by the router.
This object provides global control on the generation of traps.
Name, OID, and Syntax Access Description