Reference (Supporting ADX v03.1.00) Owner's manual

54 Brocade Virtual ADX MIB Reference
53-1003312-01
Switch port information
snSwIfInfoConnectorType
brcdIp.1.1.3.3.5.1.9
Syntax: Integer
Read only Shows the type of connector that the port offers:
• other(1) – Other or unknown connector
• copper(2) – Copper connector
• fiber(3) – Fiber connector This describes the physical
connector type
snSwIfInfoAdminStatus
brcdIp.1.1.3.3.5.1.10
Syntax: Integer
Read-write Shows the desired state of all ports.
• up(1) – Ready to pass packets
• down(2)
• testing(3) – No operational packets can be passed (same as
ifAdminStatus in MIB-II)
snSwIfInfoLinkStatus
brcdIp.1.1.3.3.5.1.11
Syntax: Integer
Read only Shows the current operational state of the interface.
• up(1) – Ready to pass packets
• down(2)
• testing(3) – No operational packets can be passed (same as
ifAdminStatus in MIB-II)
snSwIfInfoPortQos
brcdIp.1.1.3.3.5.1.12
Syntax: Integer
Read-write Indicates the quality of service level selected for the port.
For stackable devices, the QoS can be one of the following:
• low(0) – low priority
• high(1) – high priority.
• level0(0) – best-effort queue
• level1(1) – normal priority queue
• level2(2) – high priority queue
• level3(3) – premium (highest-priority) queue
For chassis devices, the values can be:
• level0(0)
• level1(1)
• level2(2)
• level3(3)
• level4(4)
• level5(5)
• level6(6)
• level7(7)
snSwIfInfoPhysAddress
brcdIp.1.1.3.3.5.1.13
Syntax: Physical address
Read only Shows the port’s physical address.
snSwIfLockAddressCount
brcdIp.1.1.3.3.5.1.14
Syntax: Integer
Read-write Indicates the number of source MAC addresses that are allowed
on the interface.
Valid values: 0 – 2048. If you enter 0 allow an unlimited number
of addresses.
Default: 8
snSwIfStpPortEnable
brcdIp.1.1.3.3.5.1.15
Syntax: Integer
Read-write Indicates if STP is enabled for the port:
• disabled(0)
• enabled(1)
Refer to the document IEEE 802.1D-1990: Section 4.5.5.2,
dot1dStpPortEnable.
snSwIfDhcpGateListId
brcdIp.1.1.3.3.5.1.16
Syntax: Integer
Read-write Specifies the ID for a DHCP gateway list entry relative to this
switch port.
Valid values: 0 – 32. A value of 0 means that the ID is
unassigned.
Name, OID, and Syntax Access Description