Reference (Supporting ADX v03.1.00) Owner's manual

60 Brocade Virtual ADX MIB Reference
53-1003312-01
Interface index lookup table
Interface index lookup table
The Interface Index Lookup Table maps ifindex values to Interface ID Lookup Table. Given an
ifIndex, this table returns the interface ID value.
snInterfaceLookupInterfaceId
brcdIp.1.1.3.3.3.1.1
Syntax: InterfaceId
Read only Shows the interface ID which consists of the following:
Octet 0 – Port type, which can be one of the following:
• 1 – Ethernet
• 2 – POS
• 3 – ATM
• 4 – Virtual
• 5 – Loopback
• 6 – GRE Tunnel
• 7 – ATM Subif (Not supported)
• 8 – MPLS Tunnel (Not supported)
• 9 – ATM PVC (Not supported)
• 10 – Management (Not supported)
• 11 – Trunk (Not supported)
• 12 – IP Tunnel (for IP tunnels, except MPLS) (Not supported)
Octet 1
• If the value of Octet 0 is 1,2,3,7 or 9, then this octet shows
the device’s slot number.
• If the value of Octet 0 is 6 or 8, then this octet shows the
tunnel ID.
• If the value of Octet 0 is 5, then this octet shows the loopback
ID.
• If the value of Octet 0 is 4, then this octet shows a virtual ID.
Octet 2 – If the value of Octet 0 is 1,2,3,7 or 9, then this octet
shows the port number.
Octet 3 – If the value of Octet 0 is 7 0r 9, then this octet shows the
ATM Subif number).
Octet 4 – If the value of Octet 0 is 9, then this octet shows the ATM
VPI number.
Octet 5 – If the value of Octet 0 is 9, then this octet shows the ATM
VCI number.
snInterfaceLookupIfIndex
brcdIp.1.1.3.3.3.1.2
Syntax: Integer32
Read only Shows the interface in the ifIndex format.
Name, OID, and Syntax Access Description
Name, OID, and Syntax Access Description
snIfIndexLookupTable
brcdIp.1.1.3.3.4
None The Interface Index Lookup Table
snIfIndexLookupEntry
brcdIp.1.1.3.3.4.1
None An entry in the IF Index Lookup Table