Reference (Supporting ADX v03.1.00) Owner's manual

Brocade Virtual ADX MIB Reference 71
53-1003312-01
Loopback interface configuration table
Loopback interface configuration table
The following objects apply to all devices, except ServerIron products.
Port STP configuration groups
The Spanning Tree Protocol (STP) eliminates Layer 2 loops in networks, by selectively blocking
some ports and allowing other ports to forward traffic, based on global (bridge) and local (port)
parameters you can configure.
The tables in this section contain information about the ports on which STP is enabled.
Port STP configuration groups (snPortStpTable)
This table applies to all devices. These devices use the snIfStpTable. Refer to the “Port STP
configuration group (snIfStpTable)” on page 74.
Name, OID, and Syntax Access Description
snLoopbackIntfConfigTable
brcdIp.1.2.13.1
None The Loopback Interface Configuration table.
snLoopbackIntfConfigEntry
brcdIp.1.2.13.1.1
None An entry in the Loopback Interface Configuration table.
snLoopbackIntfConfigPortIndex
brcdIp.1.2.13.1.1.1
Syntax: Integer
Read only Shows the port index for loopback interface configuration
entry. There can be up to eight entries in this table.
snLoopbackIntfMode
brcdIp.1.2.13.1.1.2
Syntax: Integer
Read-write Indicates if loopback interface is enabled:
• disabled(0)
• enabled(1)
snLoopbackIntfRowStatus
brcdIp.1.2.13.1.1.3
Syntax: Integer
Read-write Controls the management of the table rows. The values that
can be written are:
• delete(3) – Delete the row
• create(4) – Create a new row
• modify(5) – Modify an existing row
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
• noSuch(0) – No such row
• invalid(1) – Row is inoperative
• valid(2) – Row exists and is valid