(Supporting ADX v03.1.00) Owner manual

194 Brocade Virtual ADX Server Load Balancing Guide
53-1003247-01
Port policy
4
4. Configure a keepalive interval under a port policy.
Virtual ADX(config-port-policy-p1)#keepalive-interval 5
Syntax: [no] keepalive-interval seconds
Refer to “Configuring a keepalive interval under a port policy” on page 196 for more details.
5. (Optional) Enter the number of times the policy will be tried before the Brocade Virtual ADX
marks the port as "UP" or "DOWN".
Virtual ADX(config-port-policy-p1)#retries 5
Syntax: retries num
The default is 3 tries.
6. (Optional) Specify the protocol value.
Virtual ADX(config-port-policy-p1)#protocol http url www.example3.com
Syntax: protocol protocol-options
Enter one of the following for protocol-options, specifying the values for the required
parameters:
• http status-code min max
• http url url
• http content-match match-list
• dns addr-query value
• dns zone value
• {ldap | ldaps} username name
• {ldap | ldaps} password password
• {ldap | ldaps} search-base-dn distinguished-name
• radius key radius-key
• radius password value
• radius nas-ip { ipv4-addr | ipv6-addr }
• radius nas-port value
7. (Optional) Enable the Layer 4 check feature in the policy.
Virtual ADX(config-port-policy-p1)#l4-check
Syntax: l4-check
By default, Layer 7 health check is enabled; however, Layer 4 health check is not. You must
enable Layer 4 health check if you want to use that feature.