(Supporting ADX v03.1.00) Owner manual

Brocade Virtual ADX Server Load Balancing Guide 267
53-1003247-01
Sample configurations
5
CSW topology
Figure 30 shows a simple CSW network topology.
FIGURE 30 CSW network topology
For the CSW configuration shown in Figure 30, the following rules apply:
• The Brocade Virtual ADX receives incoming traffic on HTTP port, VIP 10.1.1.100.
• The Brocade Virtual ADX is configured with content switching (CSW) rules and policies. Policy 1
is defined to rewrite URL content and forward the request to the Web server 1.
• If a CSW rule is matched, the Brocade Virtual ADX rewrites the HTTP request and forwards it to
Web Server 1 with server ID 1025 and IP address 10.1.1.1.
• If no CSW rule is matched, the Brocade Virtual ADX takes the default action, sending the HTTP
request to Web Server 2 with server ID 1026 and IP address 10.1.1.2.
Request delete configuration
The following sections describe a full configuration process for an HTTP URL Rewrite, and a
configuration process for HTTP URL Rewrite actions.
Request delete configuration example
This section describes how to perform a complete configuration HTTP URL Rewrite, using the
content delete option. This scenario uses all of the required steps to configure HTTP URL Rewrite,
and identifies the steps that are optional.
The configuration process contains the following segments:
• “Creating a policy with HTTP URL Rewrite” on page 268
• “Configuring real and virtual servers” on page 269
• “Enabling content switching” on page 270
• “HTTP URL Rewrite configuration summary” on page 270