(Supporting ADX v03.1.00) Owner manual

314 Brocade Virtual ADX Server Load Balancing Guide
53-1003247-01
Configuring additional HA parameters
6
Source-NAT in Hot Standby
Figure 38 shows a configuration for seamless failover in Hot Standby when Source-NAT is enabled.
FIGURE 38 Seamless failover in Hot Standby HA when Source-NAT is enabled
Configuring additional HA parameters
This section provides additional configuration parameters for Hot Standby HA:
• “Configuring a backup group ID”
• “Setting the backup timer”
• “Enabling backup preference”
• “Configuring failover based on active VIP count”
• “Configuring failover based on the number of active virtual ports”
• “Delayed failover”
• “Configuring a Brocade Virtual ADX to remain in standby state”