(Supporting ADX v03.1.00) Owner manual

Brocade Virtual ADX Server Load Balancing Guide 359
53-1003247-01
Using the debug filter command
B
Table 36 displays the Ethernet Filter settings.
Table 37 displays the IP Filter settings.
Table 38 displays the TCP Filter settings.
Table 39 displays the UDP Filter settings.
TABLE 36 Ethernet Filter Settings
CLI Command Filter Type
mac bcast Ethernet broadcast packets
mac dest mac-address Packets with the specified destination MAC address
mac mcast Ethernet multicast packets
mac src mac-address Packets with the specified source MAC address
mac type type-in-hex Packets of the specified Layer 3 type
TABLE 37 IP Filter Settings
CLI Command Filter Type
ip bcast IP broadcast packets
ip dest ip-address Packets with the specified destination IP address
ip mcast IP multicast packets
ip protocol protocol-in-hex Packets with the specified Layer 4 protocol
ip src ip-address Packets with the specified source IP address
TABLE 38 TCP Filter Settings
CLI Command Filter Type
tcp src port-number Packets with the specified source TCP port
tcp dest port-number Packets with the specified destination TCP port
tcp syn TCP packets with the SYN flag on
tcp reset TCP packets with the RST flag on
tcp fin TCP packets with the FIN flag on
tcp ack TCP packets with the ACK flag on
tcp push TCP packets with the PSN flag on
tcp urgent TCP packets with the URG flag on
TABLE 39 UDP Filter Settings
CLI Command Filter Type
udp src port-number Packets with the specified source UDP port
udp dest port-number Packets with the specified destination UDP port
tcp syn TCP packets with the SYN flag on
tcp reset TCP packets with the RST flag on
tcp fin TCP packets with the FIN flag on