(Supporting ADX v03.1.00) User Manual

Brocade Virtual ADX Switch and Router Guide 137
53-1003246-01
Displaying OSPF information
6
Displaying OSPF information
You can use CLI commands and Web management options to display the following OSPF
information:
• Trap, area, and interface information – refer to “Displaying general OSPF configuration
information” on page 137.
• CPU utilization statistics – refer to “Displaying CPU utilization statistics” on page 138.
• Area information – refer to “Displaying OSPF area information” on page 140.
• Neighbor information – refer to “Displaying OSPF neighbor information” on page 140.
• Interface information – refer to “Displaying OSPF interface information” on page 143.
• Route information – refer to “Displaying OSPF route information” on page 144.
• External link state information – refer to “Displaying OSPF external link state information” on
page 145.
• Link state information – refer to “Displaying OSPF link state information” on page 147.
• Virtual Neighbor information – refer to “Displaying OSPF virtual neighbor information” on
page 148.
• Virtual Link information – refer to “Displaying OSPF virtual link information” on page 148.
• ABR and ASBR information – refer to “Displaying OSPF ABR and ASBR information” on
page 148.
• Trap state information – refer to “Displaying OSPF trap status” on page 148.
Displaying general OSPF configuration information
To display general OSPF configuration information, enter the following command at any CLI level.