(Supporting ADX v03.1.00) User Manual

Brocade Virtual ADX Switch and Router Guide 305
53-1003246-01
Displaying BGP4 information
8
route-map setcomm permit 1
set community 1234:2345 no-export
This example shows the active configuration for a route map named “setcomm“.
Syntax: show route-map [map-name]
Displaying AS4 details
This section describes the use of the following show commands, which produce output that
includes information about AS4s. Information that reflects AS4s appears in bold.
• show ip bgp neighbor shows whether the AS4 capability is enabled.
• show ip bgp attribute-entries shows AS4 path values and extended community values.
• show ip bgp shows the route entries with two and AS4 path information.
• show route-map shows the presence of any AS4 configuration data.
• show ip as-path-access-lists shows the presence of any AS4 configuration data.
• show ip bgp config shows the presence of any AS4 configuration data.
Route entries with four-byte path information
The show ip bgp command without of any optional parameters display AS4 path information, as
indicated by the bold text in this example.
.
Syntax: show ip bgp
Current AS numbers
To display current AS numbers, use the show ip bgp neighbors command at any level of the CLI.
Virtual ADX-mu2(config)#show ip bgp
Total number of BGP Routes: 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal, S
stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 10.1.1.0/24 192.168.1.5 1 100 0 90000 100 200 65535
65536 65537 65538 65539 75000