(Supporting ADX v03.1.00) User Manual

Brocade Virtual ADX Switch and Router Guide 85
53-1003246-01
Displaying IP configuration information and statistics
4
Syntax: ip bootp-gateway ip-addr
Displaying IP configuration information and statistics
To display IP information on a Virtual ADX, refer to “Displaying IP information” on page 85.
Changing the network mask display to prefix format
By default, the CLI displays network masks in classical IP address format (example:
255.255.255.0). You can change the displays to prefix format using the following CLI method.
To enable CIDR format for displaying network masks, entering the following command at the global
CONFIG level of the CLI.
Virtual ADX(config)# ip show-subnet-length
Syntax: [no] ip show-subnet-length
Displaying IP information
You can display the following IP configuration information statistics on a Virtual ADX:
• Global IP parameter settings and IP access policies – refer to “Displaying global IP
configuration information” on page 85.
• CPU utilization statistics – refer to “Displaying Protocol CPU utilization statistics” on page 87.
• IP interfaces – refer to “Displaying IP interface information” on page 87.
• ARP entries – refer to “Displaying ARP entries” on page 89.
• Static ARP entries – refer to “Displaying ARP entries” on page 89.
• IP forwarding cache – refer to “Displaying the forwarding cache” on page 92.
• IP route table – refer to “” on page 93.
• IP traffic statistics – refer to “Displaying IP traffic statistics” on page 94.
The sections below describe how to display this information.
Displaying global IP configuration information
To display global IP configuration information for the router, use one of the following methods.
Using the CLI
To display IP configuration information, enter the following command at any CLI level.