Programmer's Guide (Supporting ADX v03.1.00) Manual

738 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
HA_ENABLE_VRRPE_NOT_SUPPORTED Enable VRRP Extended failed. Must disable VRRP before
enabling VRRP Extended.
HA_INVALID_BACKUP_DELAY Failover delay value is not in range. Maximum allowed
value is 1200 (20 min), Please specify a valid value.
HA_INVALID_BACKUP_GROUP_ID The specified backup group ID value is not in range.
Please specify a valid value in the range of 0 to 127.
HA_INVALID_BACKUP_PREFERENCE The specified backup preference value is not in range.
Please specify a valid value in the range of 5 to 30.
HA_INVALID_BACKUP_TIMER The specified backup timer value is not in range. Please
specify a valid value in the range of 5 to 100.
HA_INVALID_SYMM_GROUP_ID The symmetric group ID is invalid. Please specify a valid
value in the range of 1 to 7.
HA_INVALID_SYMM_MAX_ACTIVE_PDU Invalid Maximum Active Symmetric PDU not receive before
take over value. Please specify a valid value in the range
of 1 to 60.
HA_INVALID_SYMM_RATE_MULTIPLE Invalid symmetric rate multiple value. Please specify a
valid value in the range of 1 to 60.
HA_INVALID_SYMM_REACT_DELAY Invalid symmetric delay value. Please specify a valid
value in the range of 1 to 120.
HA_SET_SYM_GROUP_ID_FAILED Cannot setup a symmetric configuration with
Active/Standby. Please disable the Active/Standby for
setting up symmetric configuration.
HA_SYM_ACTIVE_FAILED Set sym-active failed. Cannot configure symmetric when
Active/Standby is configured.
HA_VIP_ALREADY_ASSIGNED_TO_VIP_GROUP VIP already assigned to VIP group. VIP %I is already in
group %d.
HA_VIP_GROUP_ALREADY_ASSIGNED_TO_VRID VIP group %d is already assigned to VRID %d. Please use
different VIP Group ID.
HA_VIP_GROUP_ID_NOT_IN_RANGE The VIP Group ID is out of range. Please specify a valid
value in the range of 1 to 100.
HISTORY_COLLECT_ALREADY_DISABLED The disable history collect operation failed. History
collection is already disabled on the device.
HISTORY_COLLECT_ALREADY_ENABLED The enable history collect operation failed. History
collection is already enabled on the device.
NAT_CONFIG_BOTH_VALUE_MAXVALUE_EXIST Both "%s" and "%s" parameters cannot be present.
Please specify either %s or %s parameter.
NAT_INSIDE_ALREADY_DISABLED NAT is already disabled on this interface. Please enable
and then disable NAT.
NAT_INSIDE_ALREADY_ENABLED NAT is already configured on this interface. Please
disable and then re-enable NAT.
NAT_INTERFACE_BOTH_INSIDE_OUTSIDE The same interface cannot be marked as both inside and
outside NAT. Please mark the interface either inside or
outside NAT.
NAT_MISSING_GLOBAL_IP_PARAM The mandatory parameter 'global IP' is missing. Please
specify a valid global IP address.
TABLE 109 List of error messages
Error String Message