Programmer's Guide (Supporting ADX v03.1.00) Manual

Brocade Virtual ADX XML API Programmer’s Guide 751
53-1003248-01
List of Error Messages
A
NET_OSPF_AREA_RANGE_MANDATORY_PARAMETER
S
The mandatory parameter IP and mask/prefix is missing.
Please specify the IP and mask/prefix to delete the OSPF
Area.
NET_OSPF_AREA_RANGE_MAX_ENTRY_EXCEEDED The specified Area Range "%s" cannot be added. The
maximum entries for the Area Range have been reached.
NET_OSPF_AREA_TYPE_MANDATORY The Area type is mandatory for configuring OSPF Area
Range. Please configure the OSPF Area type.
NET_OSPF_AREAID_INVALID The Area ID "%s" is invalid. Please specify a valid Area ID
value in the range of "0" to "2147483647".
NET_OSPF_AREAID_MISSING The OSPF Area ID is missing. Please specify a valid OSPF
Area ID.
NET_OSPF_AREAID_NOT_CONFIGURED The specified Area ID "%s" is not configured. Please
configure the Area ID first.
NET_OSPF_BACKBONE_CANNOT_BE_NSSA The back bone Area cannot be configured as NSSA.
Please specify a normal Area.
NET_OSPF_BACKBONE_CANNOT_BE_STUB The back bone Area cannot be configured as a stub.
Please specify a normal Area.
NET_OSPF_BORDER_ROUTERS_MISSING The OSPF border routers are missing. Please configure
the OSPF Border Routers.
NET_OSPF_CANT_DELETE_AREA_RANGE Failed to delete the Area Range for the specified Area ID
%d. Please specify a valid Area ID, IP and mask.
NET_OSPF_COST_EXCEEDED The specified cost %u is out of bounds. Please specify a
valid cost value in the range of 1 to 65535.
NET_OSPF_DEFAULT_INFORMATION_ORIGINATE_ALR
EADY_ENABLED
The default information originate is already enabled.
Please disable the default information originate before
enabling any other options.
NET_OSPF_DEFAULT_INFORMATION_ORIGINATE_DIS
ABLED
The default-information-originate is disabled. Please
enable the default-information-originate.
NET_OSPF_DEFAULT_INFORMATION_ORIGINATE_NOT
_APPLICABLE
The default-info-originate is not applicable for the normal
and stubby Area type. The default-info-originate option is
only applicable for NSSA.
NET_OSPF_DISABLED OSPF is disabled. Please enable OSPF first.
NET_OSPF_GLOBAL_CONFIG_MISSING The OSPF global configuration parameter is missing.
Please specify the configuration parameter.
NET_OSPF_HELLO_LESS_DEAD_INTERVAL The Hello Interval is greater than the Dead Interval %d.
Please specify the Hello Interval that is less than the Dead
Interval.
NET_OSPF_HOLD_DELAY_MANDATORY The SPF hold time and delay are necessary for the timer
command. Please specify both the SPF hold time and
delay.
NET_OSPF_IF_EXIST_ERROR Unable to delete the OSPF Area. Deletion of the OSPF
Area is not allowed when the Area ID exists at the
interface level.
NET_OSPF_AUTHENTICATION_KEY_TOO_LONG
TABLE 109 List of error messages
Error String Message