Programmer's Guide (Supporting ADX v03.1.00) Manual

754 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
NET_OSPF_ROUTE_MISSING The OSPF routing entries are not available. Please
configure the OSPF routing entries.
NET_OSPF_SYSTEM_BUSY The OSPF database is busy. Please try again later.
NET_OSPF_TABLE_FULL Failed to configure the OSPF Area. Please delete the
unused OSPF Areas (if any).
NET_OSPF_UNABLE_TO_SET_AREA_RANGE Failed to configure the Area Range. Please configure the
Area ID first.
NET_OSPF3_ROUTING_NOT_ENABLED The OSPFv3 routing process is not enabled. Please
configure an OSPFv3 routing.
NET_OSPFV3_ALREADY_ENABLED OSPFv3 instance already exists. Only one OSPFv3
instance can exist at a time.
NET_OSPFV3_AUTH_CHANGE_WAIT_TIME_NOT_APPL
ICABLE
The specified option authentication change wait time, is
not applicable for OSPFv3. The option authentication
change wait time is applicable only for OSPFv2.
NET_OSPFV3_AUTH_KEY_NOT_APPLICABLE The specified option authentication key, is not applicable
for OSPFv3. The option authentication key is applicable
only for OSPFv2.
NET_OSPFV3_CANT_CHANGE_AREA_TYPE Cannot change an existing Area type to NSSA or
Non-NSSA for the Area ID %u. Please remove this Area
first.
NET_OSPFV3_CANT_CHANGE_EXISTING_AREA_TYPE Cannot change the Area type for the specified Area "%s".
You cannot change the existing Area type for the specified
Area.
NET_OSPFV3_DIFF_KEY The specified key is different for SA with SPI %u. Please
specify a different key.
NET_OSPFV3_DISABLED OSPFv3 is disabled. Please enable OSPFv3 first.
NET_OSPFV3_INVALID_DEAD_INTERVAL The specified OSPFv3 Dead Interval %u is invalid. Please
specify a valid OSPFv3 Dead Interval value in the range of
1 to 65535.
NET_OSPFV3_INVALID_INSTANCE The specified OSPFv3 instance %u is invalid. Please
specify a valid OSPFv3 instance value in the range of 0 to
255.
NET_OSPFV3_INVALID_IPSEC_KEY The specified IPsec key "%s" is invalid. Please specify a
valid IPsec key with 40 digits.
NET_OSPFV3_INVALID_PREFIX The specified prefix %d is invalid. Please specify a valid
prefix value in the range of 32 to 128.
NET_OSPFV3_INVALID_SPINUM The specified spinum %u is invalid. Please specify a valid
spinum value in the range of 256 to 4294967295.
NET_OSPFV3_INVALID_STUB_NSSA_METRIC The specified metric %u for STUB and NSSA type for
OSPFv3 is invalid. Please specify a valid metric value in
the range of 1 to 1048575.
NET_OSPFV3_IPV6_ROUTING_DISABLED OSPFv3 cannot be enabled. You must enable IPv6 routing
first before you can enable OSPFv3.
NET_OSPFV3_LINK_STATE_DATABASE_MISSING The OSPFv3 link state database entries are missing.
Please configure an OSPFv3 database.
TABLE 109 List of error messages
Error String Message