Programmer's Guide (Supporting ADX v03.1.00) Manual

Brocade Virtual ADX XML API Programmer’s Guide 757
53-1003248-01
List of Error Messages
A
NET_SWITCH_IP_ADDRESS_IN_RESERVED_RANGE The specified IP address %I (subnet mask %I) is in
reserved range. Please specify any IP address apart from
reserved range from %I to %I.
NET_SWITCH_IP_CONFIG_INFO_NEEDED The Switch IP configuration is missing. Please specify a
valid Switch IP configuration.
NET_SWITCH_IP_INFO_NEEDED The Switch IP and default gateway information is missing.
Please specify valid Switch IP or default gateway
information.
NET_SWITCH_NOT_SUPPORTED The API %s is not supported on Switch. Please use the
"Router" build to check this API.
NET_TCP_MSS_DESTINATION_IP_NOT_FOUND The specified TCP MSS configuration for destination
address "%s" is not found. Please specify a configured
destination address.
NET_TCP_MSS_NOT_FOUND The specified TCP MSS value %u is not configured. Please
specify TCP MSS value which is already configured.
NET_TCP_MSS_V6_OUT_OF_RANGE The specified TCP IPv6 MSS value %u is out of range.
Please specify a valid value in the range of %u to %u.
NET_VLAN_ALREADY_EXIST The specified VLAN %d already exists. Please specify a
different VLAN.
NET_VLAN_CANNOT_MODIFY_DEFAULT_ID The default VLAN ID cannot be created or updated.
Please specify a different VLAN ID.
NET_VLAN_CREATE_FAILED Create VLAN %d failed. There is no free Layer 2 VLAN
entry.
NET_VLAN_DOESNOT_EXIST The specified VLAN "%s" does not exist. Please specify an
existing VLAN.
NET_VLAN_DOT1X_PORTS Some of the specified ports are dot1x enabled and cannot
be tagged as ports. The ports that are dot1x enabled
cannot be tagged as ports.
NET_VLAN_DYNAMIC_GVRP The specified VLAN %d is a dynamic member of GVRP.
This command can only be applied to static VLANs.
NET_VLAN_GROUP_DOESNOT_EXISTS The specified VLAN group ID %d does not exist. Please
specify an existing VLAN group ID.
NET_VLAN_GROUP_DOESNOT_EXISTS_EX The specified VLAN Group ID "%s" does not exist. Please
specify an existing VLAN group ID.
NET_VLAN_GROUP_ID_INVALID The specified VLAN group ID is invalid. Please specify a
valid value in the range of 1 to %d.
NET_VLAN_GROUP_ILLEGAL_CMD The starting VLAN number cannot be greater than the
ending VLAN number. Specify a starting VLAN number
that is smaller than the ending VLAN number
NET_VLAN_GROUP_INSIDE You are already inside the specified VLAN group "%s".
Please proceed with the VLAN configuration.
NET_VLAN_GROUP_NO_FREE_L2_VLAN Adding the Layer 2 VLAN failed. There is not enough free
memory to add the Layer 2 VLAN entry.
NET_VLAN_GROUP_NOT_CONFIGURED No VLAN group is configured for this VLAN group ID.
Please configure the VLAN group for this VLAN group ID.
TABLE 109 List of error messages
Error String Message