Programmer's Guide (Supporting ADX v03.1.00) Manual

790 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
SLB_SNMP_MISSING Cannot find SNMP server %I. Please specify the valid
SNMP server.
SLB_SNMP_OID_INVALID The SNMP request OID value is out of range. Please
specify a valid Interval in the range of %d to %d.
SLB_SNMP_OID_MAX MIB Object ID must be less than %d. Please specify the
MIB Object ID to be less than %d.
SLB_SOURCE_NACT_ACL_ID_INVALID The source NAT ACL ID value is out of range. Please
specify a valid Interval in the range of %d to %d.
SLB_SOURCE_NAT_ACL_IPV6 The ACL based source NAT is not supported for IPv6.
SLB_SOURCE_NAT_ACL_UNSUPPORTED_FOR_IPV6_
VSRVR_TO_IPV4_RSRVR_BINDING
The specified IPv4 Real Server "%s" (%I) has been
configured with the source NAT ACL and cannot be bound
with the IPv6 Virtual Server "%s" (%I). Please specify a
Real Server without the source NAT ACL configuration.
SLB_SOURCE_NAT_NOT_SUPPORTED The source NAT not supported by the cache server. Please
do not specify any source NAT for the cache server.
SLB_SOURCEIP_INVALID The specified IP address is not a configured source IP.
Please configure the IP address as a source IP.
SLB_SSL_PROXY_DEFAULT_VIP_PORT_UNSUPPORTE
D
Cannot configure SSL proxy on the specified VIP port
"%s":"%s ". Please specify a valid and non-default VIP
port.
SLB_SSL_PROXY_ON_VIP_PORT_STATELESS_UNSUP
PORTED
Cannot configure SSL proxy on the specified virtual port
"%s":"%s". Virtual port is already configured for stateless;
remove it before configuring SSL proxy.
SLB_SSL_TERMINATE_DEFAULT_VIP_PORT_UNSUPP
ORTED
Cannot configure SSL terminate on the specified default
VIP port "%s":"%s". Please specify a valid and non-default
VIP port.
SLB_SSL_TERMINATE_ON_VIP_PORT_STATELESS_UN
SUPPORTED
Cannot configure SSL terminate on the virtual port
"%s":"%s". The virtual port is already configured for
stateless; remove this configuration before you can
configure SSL terminate.
SLB_STATUS_CODE_ALREADY_EXISTS The specified status code pair %d-%d already exists.
Please specify a unique status code pair.
SLB_STATUS_CODE_EXCEEDS_INPUT The specified input has exceeded the maximum number
of status code pairs allowed. Please specify a maximum
of 4 status code pairs.
SLB_STATUS_CODE_MAX_OUT_OF_RANGE The specified status code maximum value %d is out of
range. Please specify a valid value in the range of %d to
%d.
SLB_STATUS_CODE_MAX_PAIRS_EXCEEDED The system has exceeded the maximum limit. Cannot
configure the status code pair %d-%d. There is already a
maximum of 4 status code pairs configured.
SLB_STATUS_CODE_MAX_PAIRS_SUPPORTED The number of status code pairs specified has exceeded
the maximum pairs supported. Please specify a
maximum of 4 status code pairs.
TABLE 109 List of error messages
Error String Message