Administrators Guide (Supporting Fabric OS v7.3.0) Manual

• Ingress rate limiting is not supported if the F_Port is in AOQ.
• Ingress rate limiting is not supported if the F_Port is part of Trunk.
• Ingress rate limiting is not supported if the F_Port is not QoS-enabled, but it connects to a QoS-
enabled AG switch port.
Ingress rate limiting is applicable only to F_Ports and FL_Ports and is available only on the following
platforms:
• Brocade DCX
• Brocade DCX-4S
• Brocade DCX 8510-4 and Brocade DCX 8510-8
• Brocade Encryption Switch
• Brocade 300
• Brocade 5100
• Brocade 5300
• Brocade 5410
• Brocade 5424
• Brocade 5450
• Brocade 5460
• Brocade 5470
• Brocade 5480
• Brocade 6510
• Brocade 6520
• Brocade 7800
• Brocade 7840
• Brocade VA-40FC
To configure the ingress rate limit feature, perform the following steps.
1. Select View > Advanced .
2. In the Port Admin tab, select a port to configure.
3. Select QoS > Enable from the Actions list.
This enables the QoS on the selected port. The QoS status is displayed in the port table.
4. Select Edit from the Actions list.
The Port Configuration wizard displays.
5. Click Next and configure the port using the predefined Ingress Rate Limits (Mb/s) values.
6. Click Next and Save to save the configuration.
NOTE
You can set the ingress rate limit even if QoS is disabled. It does not take effect until QoS is
enabled.
Managing Ports
102 Web Tools Administrator's Guide
53-1003169-01