Administrators Guide (Supporting Fabric OS v7.3.0) Manual

To configure In-Band Management, perform the following steps.
1. Select Port Admin > GigE Ports > In-Band IP Interface.
2. Click Add to configure a new In-Band Management entry.
3. Set the IP Address Type to IPv4.
4. Set the address options:
• IP Address
• Subnet Mask
• MTU Size
5. Click OK.
6. Select the Inband IP Routes tab.
7. Click Add to configure a new route entry.
You can create a maximum of 32 In-band IP route entries.
8. Set the IP Address Type to either IPv4 or IPv6.
9. Set the address options of the management station on the WAN side of the FCIP platform:
• Destination IP Address
• Subnet Mask
• Gateway IP Address
10.Click OK.
11.Select the General subtab.
12.Select the Enable option from the Inband selection list to activate In-Band Management.
GigE port modes
Web Tools allows you to set the GigE port mode for the FX8-24 extension blades to 1 Gbps, 10 Gbps,
or dual modes.
To configure the GigE port mode, perform the following steps.
NOTE
You must install the FX8-24 extension blade in a slot containing a 10 GE license to configure the
mode.
1. Select Port Admin > GigE Ports.
2. Select View > Advanced.
3. Select a slot from the GigE Ports Explorer panel.
4. Select one of the following modes from Mode under the Actions list.
• 1G - To enable ge0 through ge9 ports.
• 10G - To enable xge0 and xge1 ports.
• Dual - To enable ge0 through ge09 and xge0 ports.
5. Click Yes on the confirmation dialog box.
GigE port modes
120 Web Tools Administrator's Guide
53-1003169-01