Administrators Guide (Supporting Fabric OS v7.3.0) Manual

Viewing the enabled zone configuration name without opening the
Zone Administration window
To view the enabled zone configuration name, perform the following steps.
Select a logical switch from the Logical Switch list in the top-right corner of the Switch Explorer
window.
The selected switch displays in the Switch View.
You can view the current zone configuration name (if one is enabled) in the lower portion of the
Switch Events and Switch Information window. If no zone configuration is enabled, the field displays
"No configuration in effect".
Viewing detailed information about the enabled zone configuration
To view detailed information about the enabled zone configuration, perform the following steps.
1. Open the Zone Administration window, as described on Opening the Zone Admin window on page
140.
The zone configuration in effect at the time you launched the Zone Administration window is
identified in the lower-right corner. It is also updated if you manually refresh the Zone
Administration window contents by clicking the refresh icon at the lower-right corner of the Zone
Administration window, or when you enable a configuration through the Zone Administration
window.
CAUTION
Clicking the refresh icon overwrites all local unsaved zoning changes. If anyone has made
any changes to the zones outside of your Zone Admin session, those changes are applied.
2. To identify the most recently effective zone configuration without saving or applying any changes you
made in the Zone Administration window, select Print > Print Effective Zone Configuration in
the Zone Administration window.
NOTE
If no zone is enabled, a message displays, indicating that there is no active zoning configuration on
the switch.
3. Optional: Click Print located in the Print Effective Zone Configuration dialog box to print the
enabled zone configuration details.
NOTE
You must use Brocade Network Advisor to print the zone database summary configurations, display
zone configuration summaries, and create configuration analysis reports.
Adding a WWN to multiple aliases and zones
This procedure enables you to configure a WWN as a member in a zone configuration prior to adding
that device to the fabric. Specifically, it is useful if you want to add a WWN to all or most zoning entities.
The added WWN does not need to currently exist in the fabric.
Viewing the enabled zone configuration name without opening the Zone Administration window
Web Tools Administrator's Guide 155
53-1003169-01