Administrators Guide (Supporting Fabric OS v7.3.0) Manual

Deleting port groups
NOTE
You cannot delete the default port group 0 (pg0).
To delete port groups, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Select Configure N-Port Groups from the Actions list.
3. In the Port Group Configuration dialog box, select the group that you want to delete and then click
Delete. A confirmation dialog box displays.
4. Click Yes to confirm the action.
Defining custom primary F-N port mapping
To manually change primary F-N port mappings, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Click the FC Ports tab.
3. Select Configure F-N Port Mappings from the Actions list.
4. Select the Primary Mappings subtab on the right side of the dialog box.
5. In the Primary Mappings area, select ports and use the Add (right arrow) button to map F_Ports or
U_Ports to N_Ports.
6. Optional: Use the Remove (left arrow) button to delete an F_Port mapping from an N_Port.
7. Optional: Define a secondary N_Port in the Secondary Failover Mappings area, by selecting the
ports using the Add and Remove buttons to set up the secondary mappings.
The secondary mappings must be to a different port in the same group as the primary mapping. If a
secondary port is not defined, the failover moves to any online ports within the same port group.
8. After you have made the appropriate changes, click Save.
Defining custom static F-N port mapping
In Fabric OS v7.0.0 and later, the Static F port mapping and Static N port mapping columns have
been added to the Port Admin GUI to display static mapping information.
NOTE
Static mappings and custom WWN-N port mappings are mutually exclusive.
To manually change static F-N port mappings, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Click the FC Ports tab.
3. Select Configure F-N Port Mappings from the Actions list.
4. Select the Static Mappings subtab on the right side of the dialog box.
5. In the Primary Mappings area, select ports and use the Add (right arrow) button to map F_Ports or
U_Ports to N_Ports.
6. Optional: Use the Remove (left arrow) button to delete an F_Port mapping from an N_Port.
7. After you have made the appropriate changes, click Save.
Deleting port groups
Web Tools Administrator's Guide 181
53-1003169-01