Administrators Guide (Supporting Fabric OS v7.3.0) Manual
Defining custom WWN-N port mappings
NOTE
Static mappings and custom WWN-N port mappings are mutually exclusive.
To manually change WWN-N port mappings, perform the following steps.
1. Select the Port Admin tab.
2. Click the FC Ports tab.
3. Select Configure WWN-N Port Mappings from the Actions list.
4. In the Primary Mappings area, select a WWN from the left pane and a group or port from the right
pane.
5. Click the Add (right arrow) button to map the WWN to the port or port group.
6. Optional: Expand the port in the right page and select the WWN and then use the Remove (left
arrow) to remove the mapping.
7. Optional: Define a failover in the Secondary Failover Mappings area, by selecting the ports using
the Add (right arrow) and Remove (left arrow) buttons to set up the secondary mappings.
The WWN fails over to the secondary mapping if the primary mapped port is offline. If a secondary
port is not defined, the failover moves to any online ports.
8. Optional: To create a detached WWN-N port mapping, enter the WWN value into the WWN field
and click Add.
The detached WWN port is now available for mapping.
9. After you have made the appropriate changes, click Save.
Any unused WWNs are discarded.
Access Gateway policy modification
Although you can control a number of policies on switches in Access Gateway mode, Web Tools only
provides the ability to enable and disable the policies. For more information on these policies, please
refer to the Access Gateway Administrator’s Guide.
Path Failover and Failback policies
The Path Failover and Failback policies determine the behavior of the F_Port if the primary mapped
N_Port they are mapped to goes offline or is disabled. The Path Failover and Failback policies are
attributes of the N_Port. By default, the Path Failover and Failback policies are enabled for all
N_Ports.
Modifying Path Failover and Failback policies
To modify Path Failover and Failback policies, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Select the N_Port for which you want to modify the policy.
3. Select Edit from the Actions list.
Defining custom WWN-N port mappings
182 Web Tools Administrator's Guide
53-1003169-01