Administrators Guide (Supporting Fabric OS v7.3.0) Manual

3. Select a trap level for a recipient from the corresponding Trap Level menu in the SNMPv1 and
SNMPv3 sections.
The level you select identifies the minimum event level that prompts a trap.
NOTE
Adding or editing the user name can be done only through the CLI and by selecting a user name
from the User Name menu in the SNMPv3 section.
4. Click Apply.
Changing the systemGroup configuration parameters
To change the systemGroup configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration
window on page 52.
2. Select the SNMP tab.
3. Enter a contact name, description, and location in the SNMP Information section.
4. Optional: Select the Enable Authentication Trap check box to allow authentication traps to be sent
to the reception IP address.
5. Click Apply.
Setting SNMPv1 configuration parameters
To set SNMPv1 configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration
window on page 52.
2. Select the SNMP tab.
3. Double-click a community string in the SNMPv1 section and enter a new community string.
4. Double-click a recipient IP address in the SNMPv1 section and enter a new IP address.
5. Click Apply.
Setting SNMPv3 configuration parameters
NOTE
The port number is not included.
To set SNMPv3 configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration
window on page 52.
2. Select the SNMP tab.
3. Select a user name from the User Name menu in the SNMPv3 section.
NOTE
The list is scrollable. If you do not see your user name, scroll down using the scroll bar or by clicking
the User Name heading.
Changing the systemGroup configuration parameters
216 Web Tools Administrator's Guide
53-1003169-01