Installation Guide

Base

Paver

BROCK

For all Patios and Walkways

The base is the most important step in your patio and walkway projects.

STEP 6

INSTALL BROCK PAVERBASE

PANELS

Starting against a straight edge of the patio, lay the Brock panels,

ensuring that the side ﬂanges overlap. Ideally, lay them in a

“brick-like” pattern (illustration below). This will ensure stability of

the panels when you lay the pavers. To off set the panels (for the

second row), cut a panel in half, using a utility knife, and start with

top piece of the panel so the ﬂange can be used. Use bottom half to

ﬁnish the next row.

Trim any curves or along edges using a utility knife. Place any extra

scrap pieces of Brock PaverBase in your recycling bin.

LEVELING SAND SCREED

BROCK PAVERBASE PANELS

STEP 5

SCREED THE SAND USING A BOARD

Using a standard 2x4 that is 6 feet long, screed the sand using the

baord along the pipe or reba, maintaining your slope so watch your

string line. Make sure the board you use is straight and true! Hand

tamp the sand and recheck to make sure you do not have any high

or low spots. Make sure that the sand is even with the top of the

concrete. Do not use a plate compactor to compact the sand.

HOW TO INSTALL

PATIOS AND WALKWAYS

Concrete Overlay – (with or without expanding

project size)