Installation Guide

DIY INSTRUCTIONS:
Transforming a Concrete Slab
to a Paver Patio
PaverBase
STEP 5: LEVEL THE SAND USING A BOARD
Screed the sand using a straight board. Use a standard 2×4, about 6 feet long, straight and true! The
board will also help you keep the slope so watch your string line.
STEP 6: INSTALL BROCK PAVERBASE PANELS
Starting against a straight edge of the patio, lay
the Brock panels, ensuring that the side flanges
overlap. Ideally, lay them in a “brick-like” pattern
(illustration below). This will ensure stability of
the panels when you lay the pavers.
Trim any curves or along edges using a razor
knife. Place any extra scrap pieces of Brock
PaverBase in your recycling bin.
LEVELING SAND SCREED
BROCK PAVERBASE PANELS