Installation Guide

DIY INSTRUCTIONS:
Transforming a Concrete Slab
to a Paver Patio
PaverBase
STEP 9: CLEAN THE SURFACE OF THE PAVERS
MAKE SURE THE SURFACE OF THE PAVERS IS CLEAN!
Once you are done spreading the polymeric sand into the gaps, use a leaf blower to blow the fine
dust o the surface of your patio. (You want to make sure you sweep it o well first or you will
generate a large dust cloud!) DO NOT WASH IT OFF WITH WATER!) THAT COMES LATER. If the patio
is not free of polymeric sand on the surface of the pavers, you may see a film/haze on the pavers once
you follow step 9.
Once the surface of the patio is completely clean, follow the instructions for wetting on the packaging
of the polymeric sand. This will entail lightly spraying the joint sand with water several times which
will activate the polymer that hardens the sand.