Manual

DOCUMENT ID 992495

PAGE 1 of 2

Radial Mount Front End Lowering Kit

For BMW S 1000 RR

INSTALL RADIAL MOUNT BRACKETS

Remove the top and bottom brake caliper

mounting bolts. Re-insert bolts through the

radial mount brackets with the notched area

facing toward the brake caliper as shown.

Torque bolts to 38 Nm (28 lb-ft). Repeat on

opposite side.

ABS models: The wheel speed sensor cable bracket will need to be moved to on

top of the radial mount bracket. Remove the cable from the bracket and install the

bracket as shown. Replace cable into the bracket.

INSTALL STRAP END KIT

Cut the short strap and end bracket from the buckle. Place

Brock’s Performance strap end bracket into the buckle,

install the supplied bolt, lock washer, and nut. Tighten the

nut securely.

Do not over tighten and distort the buckle, the

release mechanism will become jammed and not function

correctly.

Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062

CUT

PAGE 1
DOCUMENT ID 992495 Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062 Radial Mount Front End Lowering Kit For BMW S 1000 RR INSTALL RADIAL MOUNT BRACKETS Remove the top and bottom brake caliper mounting bolts. Re-insert bolts through the radial mount brackets with the notched area facing toward the brake caliper as shown. Torque bolts to 38 Nm (28 lb-ft). Repeat on opposite side.
PAGE 2
DOCUMENT ID 992495 INSTALL STRAP Always route strap under any cables and wires to prevent pinching or damage. Do not allow the strap to twist. On each side of the frame at the steering neck are zip ties securing wiring to clips, cut the zip ties to release the wires from the clips and place zip ties around the wires only. Install the release buckle on the left side of the bike (while seated) using the M10x25 bolt and serrated washer. Hand tighten.