Operating Guide

LIGHTING
6
BASIC GAS GRILL COMPONENTS
A. Main burner
controls
B. Side burner
control
C. Rear burner
control
D. Ignitor
E. Manual lighting
hole
F. Handle
G. Side burner
H. Cylinder valve
I. Regulator
LIGHTING INSTRUCTIONS
1. The appliance must be assembled as per the
assembly instructions.
2. Ensure LP cylinder is full and properly connected to
the regulator. See: “Hose and Regulator.” (Page 4)
3. Ensure there are no gas leaks in the gas supply
system. See: “Leak Testing.” (Page 5)
4. Ensure that the venturi tubes are properly located over
the gas valve orifices. See Venturi diagram. (Page 5)
5. Ensure that both Main Burner and Side Burner
ignition wires are connected.
6. Carefully review all instructions on the information
plate attached to the gas grill.
7. WARNING: Always open lid before lighting and do
not lean over gas grill while lighting.
8. Set control knobs to “OFF” and turn on the gas supply.
LIGHTING THE MAIN BURNER:
a. Open gas grill lid and leave open until lit.
b. Check that the battery has been installed in the
electronic ignition.
c. Push and turn one main burner control knob to “HIGH.”
d. Push and hold down the ignitor button or use match to
light.
e. Burner should ignite within 5 seconds; turn off gas
source immediately if ignition does not occur in this
timeframe.
T o light burner with a match proceed
below to step f.
f. Insert lit match through lighting hole located at the
bottom right of the cookbox.
g. Push and turn right main burner control knob to “HIGH.”
h. Burner should ignite within 5 seconds.
i. After the first burner is lit, push and turn the adjacent
main burner control knob to “HIGH” then repeat for
other burners; these burners should light automatically
without the ignitor.
Note: In windy conditions, ignite each burner individually.
Use the match holder to lower a lit match to light each
burner.
LIGHTING THE SIDE BURNER:
a. Push and turn side burner control knob to “HIGH.”
b. Push and hold the ignitor button.
c. Burner should ignite within 5 seconds. To light burner
with a match proceed below to step d.
d. Apply lit match to burner ports.
e. Push in the side burner control knob and turn to “HIGH.”
f. Burner should ignite within 5 seconds.
Note: Pots on the side burner must not exceed 9” (23 cm)
in diameter or 15 lbs. (7 kg) in weight.
LIGHTING THE REAR ROTISSERIE
BURNER:
Warning: do not operate the main burner simultaneously with
the rear burner.
b. REMOVE THE WARMING RACK.
c. Push and turn rear burner control knob to “HIGH.”
d. Push and hold the ignitor button.
e. Burner should ignite within 5 seconds. To light burner
with a match proceed below to step f.
f. Apply lit match to burner ports.
g. Push in the rear burner control knob and turn to “HIGH.”
h. Burner should ignite within 5 seconds.
CAUTION: Check your gas grill after lighting. All burner
ports should show a 2.5cm / 1” flame on “HIGH.”
If any of the following symptoms occur there is
probably a blockage in the venturi tubes. Shut off
gas at once and clean the venturi tubes. See “Venturi
Tubes.” (Page 5)
1. You smell gas.
2. A flashback fire occurs.
3. Your gas grill heats unevenly.
4. The burners make popping noises.
IF BURNER DOES NOT IGNITE:
1. Push and turn control knob to “OFF.” Wait 5 minutes
then try again with control knob set at “MEDIUM.”
2. If any burner will not light, see “Troubleshooting” on
page 11. If problem persists, do not attempt to
operate the appliance; contact OMC, your dealer or an
approved service center.
SHUTDOWN:
1. Turn off cylinder valve.
2. Turn control knobs to “OFF.”